Making Your Own Arduino Part 1 (Burning Bootloader)

Diy Arduino 1 Banner
Need more Arduinos? Don’t go out and spend on another one. Why don’t make one yourself? 🙂

In this post I’m going to focus on the heart of an Arduino, the Atmel ATmega 328P.

A brief introduction on this little beast.

  • 8-bit MCU
  • 32kB Flash Memory
  • 1kB EEPROM
  • 2kB SRAM
  • 23 general purpose IO lines
  • 6-channel 10 bit ADC
  • SPI and I2C capabilities

The ATmega 328P first appeared on the Arduino Duemilanove where it replaces the ATmega 168 which has a smaller program memory.

I tried to get one from Jalan Pasar but it costs RM 40+, an outrageous price. Decided to get it online from Cytron together with the USB to UART adapter which I will highlight in the next post.

Ordered on Saturday, arrived on Monday morning.

The ATmega 328P, they even applied a sticker on it to clearly show the function of each pin. Some may like it, some may not but I don’t mind it at all. Thanks Cytron 🙂

To burn the bootloader on the new chip, you need another Arduino. In this demonstration I used my Uno R3.

First things first, before we start, we need to upload the Arduino ISP sketch into the Uno R3. I uploaded the one from the 0023 version because the 1.0 was giving me problems.

Next, following the guide found on the official Arduino website (here), here is the blank ATmega 328P MCU connected to the Uno R3.

BreadboardAVR[1]

Now fire up the Arduino 1.0 IDE, under Tools and Programmer, select Arduino as ISP.

To start the process, simply click on Burn Bootloader.

This will take some time, here’s a video of the whole process.

When the TX and RX lights stop flashing, it’s done.

To test it, I swapped the original ATmega 328P on my Uno R3 to the new one I just got from Cytron.

It works! Stay tuned for Part 2 where I’ll be assembling a full circuit on the breadboard and program it using a USB to UART converter.

  1. Avinash Chaure03-18-2015

    Can I use above same for Atmega 8 ??

  2. Rishabh gupta07-08-2014

    on video you are using capacitor on arduino board please give a detail about that….

  3. vick07-03-2012

    When burn the bootloader to a new Atmega 328, the existing Atmega 328 in the arduino board still in the board or need to be removed ? And this is the connction to burn the bootloader without using the AVR programmer. How about if I want to make my arduino as AVR programmer to upload the code into AVR chip that do not have bootloader ? not using arduino language to program. Is it same connection as well using all those MOSI, MISO, SCK RESET, VCC, GND ?

    Thank you

Leave a Reply to Avinash Chaure Click here to cancel reply.